Decora® ODS15-IDW 1-Pole Single Relay Wall Mount Occupancy Sensor, 120/230/277 VAC, Passive Infrared Sensor, 180 deg

Occupancy Sensors
7858 MFG #: ODS15-IDW
61.61000 / ea
The ODS15-ID uses passive infrared (PIR) detection technology to monitor a room for occupancy through a segmented fresnel lens. This specialized lens divides the field-of-view into sensor zone. When a person passes into or out of a sensor zone the sensor detects motion and switches the lights ON. The lights will remain ON as long as there is an occupant moving through the sensor zone. A delayed-off time adjustment prevents the lights from switching off when the space is occupied. In order to keep the lights-on, a person must pass through a sensor zoneat least once during the selected delayed-off time interval. An LED indicator blinks each time the unit detects activity in the sensor zone. When the space being monitored by the sensor is unoccupied for the length of time chosen as the delayed-off interval, the unit will beep 3 times. Ten seconds after the last warning beep, the unit will switch the lights OFF.
  • Applications
  • Features
Fits in Standard Wallbox and Replaces Single-Pole Wall Switch, Ground Connection Required, Gangable with other Units, Low-Profile Design Eliminates Obtrusive "scanning-device" Look, Elegant Decora Wallplates Complement any Interior for Sleek Aesthetics, U
Fits in standard wallbox and replaces 1-pole wall switch, ground connection required, gangable with other units
Low profile design eliminates obtrusive "scanning device" look
Convenient pushbutton provides manual ON/OFF light switching at any time
Two dual element PIR sensors used to widen detection range, relay switches at the zero crossing point of the AC power curve to ensure maximum contact life and compatibility with electronic ballasts
Segmented fresnel lens provides optimum sensitivity and performance designed with an extensive "minor motion" area where even slight body movements will be detected
Vandal resistant PIR lens, 1-unit can be used for 120 to 277 VAC lighting, compatible with both electronic and magnetic ballasts
Horizontal field-of-view may be adjusted between 180 and 60 deg of arc by using integral blinders located on either side of the lens, no masking tape required
Manual ON/auto OFF mode for installations where manual ON switching is required but auto OFF switching is still desired for CEC title T24 energy savings
To comply with T24, red LED indicator light flashes when sensor detects motion to verify detection is active
Time delay in adapting mode, the time delay can be configured from 30 sec (test mode), 5, 10 and 20 min, in non-adapting mode, the delay can be configured from 5, 10, 20 and 30 min
Light sensor adjustable ambient light override ranges from approximately 20 to 5000+ LUX to prevent lights from turning ON automatically during periods of ample natural light, increasing energy savings
Light sensor enables the load hold OFF feature once level has been set, no neutral design is optional for retrofit applications
Self-adjusting delayed OFF time interval compensates for real time occupancy patterns, preventing unnecessary ON/OFF switching
Exclusive Walk-through feature provides increased energy savings by not leaving the lights ON for an extended period after only momentary occupancy
Vacancy confirmation when the time out expires and the relays turns OFF, a 30 sec vacancy confirmation exists to turn the relays back ON
False detection circuitry
Presentation mode feature for slide or film presentations allows pushbuttons to turn lights OFF and keep them OFF while the room is occupied
Additional manual service switch provided for installer to force lights to hold OFF or hold-ON during installation
Beep warn - unit beeps 3 times after delayed OFF time expires, then waits 10 sec before turning lights OFF
Exclusive Leviton® high inrush stability (HIS) circuitry, specifically designed to handle today's high inrush electronic ballast loads and offer unmatched durability and service