Banner Engineering SLPCP25-690P88 CASCADING LIG

EZ-Screen Low-Profile Safety Cascading Light Screen, Resolution: 25 MM, Protected Height: 690 MM, Operating Range: 0.1 - 7 MR, Effective Aperture Angle: Plus/Minus 2.5 DEG At 3 MR, Response Time: 12.5 MS, Safety Output Rating: Two Redundant Solid-State 24 VDC, 0.5 AMP Maximum Sourcing Output Signal Switching Device, Auxiliary Output Ratings: 24 VDC At 250 MILAMP Maximum Current-Sourcing (PNP) Solid-State Output, Light Source: 850 NMTR Infrared LED, Indicator: Emitter: (1) Bi-Color (Red/Green) Status Indicator, 7- Segment Diagnostic Indicator (1 Digit); Receiver: Yellow Reset Indicator, Bi-Color (Red/Green) Status And Zone Status Indicator, 7- Segment Diagnostic Indicator (3 Digit), Yellow Mute Device Input Indicators, Power Supply: Emitter: 60 MILAMP Maximum, Exclusive Of Fault Load; Receiver: 150 MILAMP Maximum, Exclusive Of OSSD1 And OSSD2 Loads, Controller: 2-Position Switch For Emitter/Receiver; Redundant Switches For Trip/Latch Output, Length: 28 MM, Width: 26 MM, Height: 689 MM, Enclosure: IP65, Extruded Aluminum Housing, Mounting: (2) 690 MM Swivel End Brackets And Side Brackets, Finish: Yellow Powder Coated, Number Of Sensing Beams: 35, Connection: 300 MM Pigtail With 8-Pin M12 Quick Disconnect, Lens: Acrylic, Operating Temperature: 0 - 55 DEG C, Light Immunity: Ambient: Greater Than 10000 LX At 5 DEG Angle Of Incidence, Recovery Time: 81 - 495 MS Beam 1(Sync Beam), 25 - 152 MS (All Other Beam), Operating Conditions: Relative Humidity: 95 PCT (Non-Condensing), Exceeds OSHA/ANSI Control Reliability Requirements, Certified To cTUVus And CE Certified To Type 4, Cat 4 PLe And SIL 3, For Finger, Hand And Ankle Protection